Your Next Building Could Store Electricity In Its Concrete

Most of us picture pavements, bridges and the dull grey walls of a parking garage when the word “concrete” comes up. In fact, concrete is actually the most commonly used building material in the world. However, as the world moves toward renewable energy, we desperately need better ways to store it.

Researchers at the Massachusetts Institute of Technology are trying to achieve this by mixing standard cement with a few specific ingredients to make ordinary structures store electricity. Instead of turning to expensive, hard-to-mine metals, researchers believe the answer might be hiding in the walls right around us.

 

How Can A Rock Hold An Electric Charge?

 

It is easy to assume that a standard building material would be a terrible place to store electricity. However, MIT researchers discovered the secret lies in combining water, standard cement and nanocarbon black. While nanocarbon black might be easily compared to ultra-fine charcoal, it’s actually produced from natural gas or petroleum products to give it an incredibly high surface area and great electrical conductivity.

This mixture is primarily a cement paste, because adding the usual sand and gravel to make standard concrete would take up valuable space needed to store the electrical charge. When the water finally reacts with the cement, it creates a branching network of microscopic holes. The carbon black then transfers into these tiny spaces and forms a connected, wire-like structure throughout the hardened block.

This process creates what scientists refer to as a supercapacitor and unlike the chemical batteries we see in our smartphones, a supercapacitor stores energy using a static electric field. It basically acts like a sponge for electricity that can soak up and release power at an incredibly fast pace. However, a single block of this cement can’t hold a charge on its own.

To make it work, two separate blocks of this cement must be placed together with a thin dividing layer between them. Once this setup is soaked in a liquid called an electrolyte, it comes to life. Consequently, electrical charges gather along the tiny carbon structures inside the blocks. A small chunk of this material will not hold nearly as much power as your smartphone battery. However, houses are built using huge amounts of cement. When you scale this technology up to the size of an entire building foundation, it’s capable of storing a highly useful amount of electricity.

 

Solving The Power Problem

 

While the initial idea was proven in 2023, the early versions had a specific limitation regarding their power capacity. You would have needed approximately 45 cubic metres of this special concrete to store enough energy to power an average home for only a day. Luckily, researchers have recently improved on this technology, which increased the energy storage capacity tenfold. Today, that same daily energy requirement can be met with just 5 cubic metres, which is about the volume of a single basement wall.

They achieved this by switching to organic electrolytes and changing how the material is made. Instead of soaking the dried concrete in an electrolyte later, they started mixing it directly into the water from the very beginning. As a result, they can cast much thicker pieces of concrete that hold significantly more power without sacrificing their structural strength.

 

 

Buildings That Can Feel Structural Stress

 

The MIT team built a small, functional arch out of their material and hooked it up to an LED light. The arch was able to successfully support its own weight and power the bulb at the same time. However, when the researchers applied extra physical pressure to the arch, the LED light flickered.

This means that physical stress temporarily changed how the electrical charges moved through the material. Because of this, future buildings could effectively monitor their own health. If a bridge or a load-bearing wall experiences too much strain from high winds, the electrical output will fluctuate and warn engineers before a dangerous collapse occurs.

 

Is This A Greener Way To Store Energy?

 

Currently, our grids rely mostly on lithium-ion batteries to store wind and solar power. Unfortunately, mining lithium and other rare metals is incredibly expensive and demands a lot from our environment.

On the other hand, cement and carbon black are easily accessible and there’s no shortage of them. This means that using these materials to store green energy is a highly promising alternative. That being said, it’s important to remember that the highest-performing versions of this concrete use organic electrolytes like acetonitrile, so the system isn’t entirely free of industrial chemicals.

We’re still in the testing phases, so you can’t go out and buy a concrete battery today. But the research shows we don’t always need complex, expensive hardware to solve modern infrastructure problems.